联系我们
推拉棚的主架、立柱等部件的安装事项
来源:https://www.lantianpengmo.com/ 日期:2022-07-30 发布人:
推拉棚是一种简易小型篷房,可以遮阳挡雨,拆搭方便。除了日常停车使用,在国内外疫情形势仍旧严峻的情况下,还可以用作防疫通道、核酸检测棚等。下面来讲讲推拉棚的主架、立柱等部件的安装事项。
The push-pull shed is a simple small tent, which can shade from the sun and rain, and is easy to dismantle and build. In addition to daily parking, it can also be used as an epidemic prevention channel and nucleic acid testing shed when the epidemic situation at home and abroad is still severe. Next, let's talk about the installation of the main frame, columns and other components of the sliding shed.
一、主架安装:
1、 Main frame installation:
推拉棚主框架有两种,一种是主框架分成两半,另一种是主框架是一个整体,主框架是一个整体不需要忽略,那么就说主框架分成两半以下内容:
There are two kinds of main frames of push-pull shed. One is that the main frame is divided into two parts, and the other is that the main frame is a whole. The main frame is a whole and does not need to be ignored. Then the main frame is divided into two parts, as follows:
查看主框架梁是否有剪式框架;没有伸缩剪刀架,不需要注意;对于伸缩式剪式框架,有必要拼接半个主框架。拼接时应注意以下内容:主框架的半横梁为螺钉,半横梁为伸缩环。拼接时,一个主框架为半螺钉和半伸缩环;(注意以下内容:一个主框架不能全是螺钉,一个主框架全是伸缩环).在主框架拼接的中间,制造商将匹配用于固定的螺钉。
Check whether the main frame beam has a shear frame; There is no telescopic scissor frame, so you don't need to pay attention; For the telescopic shear frame, it is necessary to splice half of the main frame. Attention should be paid to the following when splicing: the half beam of the main frame is a screw, and the half beam is an expansion ring. When splicing, one main frame is half screw and half telescopic ring; (note the following: a main frame cannot be all screws, and a main frame is all telescopic rings). In the middle of the main frame splicing, the manufacturer will match the screws used for fixing.
二、立柱的安装:
2、 Installation of columns:
当生产和制造推拉棚主框架部件时,我们将启动立柱。一般来说,我们都有立柱。对于一些相对较长尺寸的产品,我们的立柱将被分开。这种连接更简单。我们只需参照立柱前部的伸缩剪刀架的方向,后部是一样的。完成后,我们将竖立立柱,每侧各有一人扶着立柱。立柱将被竖立起来。第三个人需要找一根水平杆将主框架插入两侧的立柱中。
When producing and manufacturing the main frame components of the sliding shed, we will start the column. Generally speaking, we all have columns. For some products with relatively long sizes, our columns will be separated. This connection is simpler. We only need to refer to the direction of the telescopic scissors frame in the front of the column, and the rear is the same. After completion, we will erect the column, with one person on each side holding the column. The column will be erected. The third person needs to find a horizontal bar to insert the main frame into the columns on both sides.
三、顶部安装:
3、 Top mount:
济南推拉棚主框架和立柱已经安装好,现在要穿上吊布。打开包装好的顶部防水布,找出活动棚防水布的长度和宽度。登上山顶时,必须从左到右,而不是从前到后。一是要避免人员上顶时不注意,移动推拉雨棚前后倾斜,造成事故;二是要节省后期的人力和时间。顶棚布组装完毕后,将立柱展开,从生产部滴胶到顶梁和横梁上。如果有一块布盖住侧面,不要先固定挂在侧面的布。如果没有布,立柱的上侧装有蝶形螺钉,用于固定顶部的悬挂棚布。
The main frame and columns of Jinan push-pull shed have been installed, and now we need to put on hanging cloth. Open the packed top waterproof cloth and find out the length and width of the waterproof cloth of the movable shed. When you climb the top of the mountain, you must go from left to right, not from front to back. First, it is necessary to avoid people not paying attention when climbing the roof, moving the push-pull canopy to tilt back and forth, causing accidents; The second is to save manpower and time in the later stage. After the ceiling cloth is assembled, unfold the column and drip glue from the production department to the roof beam and beam. If there is a cloth covering the side, do not fix the cloth hanging on the side first. If there is no cloth, butterfly screws are installed on the upper side of the column to fix the hanging shed cloth on the top.
四、固定安装:
4、 Fixed installation:
现在整个移动推拉雨棚已经组装好,雨棚在使用前固定,以延长移动推拉雨棚的使用寿命。基本上有两种固定方式以下内容:一种是车轮固定。我们将匹配链条和顶部防爆螺钉,将车轮固定在地面上。另一种方法是拉动钢丝绳,在活动遮棚前后四个方向固定一根绳子,以防止它被大风吹走。根据特殊性质,还有一些其他的固定装置,也会有一些特殊的固定装置。
Now the whole mobile push-pull canopy has been assembled and fixed before use to extend the service life of the mobile push-pull canopy. Basically, there are two fixing methods: one is wheel fixing. We will match the chain and the top explosion-proof screw to fix the wheel on the ground. Another method is to pull the steel wire rope and fix a rope in four directions before and after the movable canopy to prevent it from being blown away by the strong wind. According to the special nature, there are some other fixed devices, and there will also be some special fixed devices.
推拉棚拆搭便捷,随搭随用;其次与固定建筑相比,推拉棚更实惠;另外推拉棚作为一种简易装配式建筑,不需要复杂的审批手续,可以快速投入使用。您有选购的需求就来我们网站https://www.lantianpengmo.com咨询了解吧。
The sliding shed is easy to dismantle and erect, and can be used as soon as it is erected; Secondly, compared with fixed buildings, push-pull sheds are more affordable; In addition, as a simple prefabricated building, the push-pull shed can be put into use quickly without complicated approval procedures. Come to our website if you need to buy https://www.lantianpengmo.com Consult and understand.
下一篇:电动遮阳篷的种类有哪些 上一篇:遮阳蓬设备定做时厂家是要谨慎选择的
此文关键词:Array Array Array Array
阅读/ Recommended reading
- 日常使用中怎么样才能保护好膜结构停车棚 2024-10-18
- 济南遮阳蓬:遮阳蓬的材料都有什么类型? 2024-09-02
- 济南遮阳蓬:家里遮阳篷不要随便安,这4点一定要留意 2024-08-27
- 济南停车棚:停车棚膜结构材料有哪些? 2024-08-26
济南停车棚:自建车棚需要的材料和工具
[2018-08-23]
材料:钢材、膜材料、亚克力板、水泥砂浆、透水砖等。钢材的选择上,可以使用10cm10cm的方管作为承重钢柱,4cm8cm的方管作为梁。车棚的顶部可以选择膜结构,这样可以增加车棚...