在户外进行遮阳蓬安装可是一项大活动，仅仅靠一个人是完成不了的，但是同时几人进行遮阳蓬安装往往会出现不协调的纰漏，这时候需要我们业余人员多多了解怎样正确的将济南遮阳蓬安装完成，了解遮阳蓬安装的6个必备知识。

Installing the awning outdoors is a big activity, which can't be completed by only one person. However, at the same time, several people often make uncoordinated mistakes when installing the awning. At this time, we need more amateur staff to understand how to correctly install the awning in Jinan, and understand the six necessary knowledge of awning installation.

1、户外遮阳篷安装条件确定：混凝土、砖墙、钢结构、木质、空心墙或需另做机构。

1. The installation conditions of outdoor awning are determined as follows: concrete, brick wall, steel structure, wood, hollow wall or other structures need to be made.

2、户外遮阳篷安装方式确定：贴墙式、吊顶式、斜吊式或其它特殊情况另做机构。

2. The installation method of outdoor sunshade shall be determined as follows: wall-attached, ceiling, inclined or other special cases.

3、户外遮阳篷的挂靠方式：分为嵌入式和外挂式

3. The hanging method of outdoor awning: it is divided into embedded type and external type

4、户外遮阳篷操纵方向的确认：人始终面对遮阳篷为基准。

4. Confirmation of operation direction of outdoor awning: people always face the awning as the benchmark.

5、户外遮阳篷预留电机接线位

5. Reserved motor wiring position for outdoor awning

6、充分考虑遮阳篷日后的保养与维护，将它设计在合理位置。

6. Give full consideration to the future maintenance of the awning, and design it in a reasonable position.

遮阳篷的安装步骤及注意事项如下：

The installation steps and precautions of the sunshade are as follows:

1、骨架桁条表面必须平整，不能有毛刺、焊疤等;如果发现这些问题一定要打磨平整以后再安装，否则会划伤表面UV涂层，导致老化的加快。

1. The surface of the framework stringer must be flat and free of burrs, welding scars, etc; If these problems are found, they must be polished and leveled before installation, otherwise the UV coating on the surface will be scratched, resulting in accelerated aging.

2、骨架上的油漆、涂料须干燥，不得残留挥发性溶剂;由于耐酸碱性较弱，必须在挥发完毕后再安装。

2. The paint and coating on the framework must be dry without residual volatile solvent; Due to weak acid and alkali resistance, it must be installed after volatilization.

3、把EPDM胶条铺设并粘贴于骨架上;这样可加固与骨架的贴切度，增加承重能力。

3. Lay and paste EPDM adhesive strips on the framework; This can strengthen the fit with the skeleton and increase the bearing capacity.

4、检测骨架上椽子间的中心距离及檩条间的中心距离，须符合设计要求;如跨距过大，会影响遮阳篷的性。

4. The center distance between rafters on the framework and between purlins shall be tested to meet the design requirements; If the span is too large, the safety of the awning will be affected.

5、用专用封口胶带封闭板材端孔后铺设板材;板材之间用H条连接，再接口处打上专用封口胶，可以有效的防止遮阳篷漏水。

5. Use special sealing tape to seal the plate end hole and lay the plate; The plates are connected with H strips, and the joint is sealed with special sealant, which can effectively prevent water leakage of the awning.

6、用一种由铝合金连接型材和密封垫，组成的装配系统将板材固定;这样遮阳篷就安装完成了。

6. Fix the plate with an assembly system composed of aluminum alloy connecting profiles and sealing gaskets; This completes the installation of the sunshade.

为了您的家人的使用遮阳篷带给您的快乐，请您在购买安装遮阳篷的时候注意请专门的人员安装!更多相关内容就来我们网站https://www.lantianpengmo.com咨询了解吧！

For your family to use the awning safely and bring you happiness, please pay attention to the special personnel when purchasing and installing the awning! Come to our website for more relevant content https://www.lantianpengmo.com Ask about it!